Models that DO have the Reverse Trigger Wire pre-installed from the factory: 2012-2014 Toyota Yaris (The Yaris Hybrid may be an exception to this) Models that DO NOT have the Reverse Trigger wire installed from the factory: If your vehicle is not on this list or if you find that this information is incorrect, please email us( and we will update the site accordingly. Some models may also have different configurations depending on the factory installed features or model year of the vehicle. Re-insert any platic trim pieces that were previously removed. This is the reverse trigger wire.ĥ) Reconnect the 28-pin connector to the back of the head unit.Ħ) Slide the head unit back into position. Note that pin 2 has an orange wire with silver bands inserted into the back of the connector. The picture on the right is from our Subaru BRZ. The picture shows where the wire should be inserted into the connector. Note that the reverse wire is not installed from the factory for a Toyota Yaris. The picture on the left is from a Toyota Yaris. If the reverse trigger wire is intalled in your connector, you will not need to install the wire yourself. Compare them to the connector on your vehicle. The connector looks like this:Ĥ) The reverse trigger wire is installed in pin 2 of this connector. This process is much easier on some vehicles than others.Ģ) Carefully remove the plastic cover around the head unit and unscrew/unbolt as appropriateģ) Slide the unit out and Unplug the 28-pin from the back of the OEM head unit. This method is requires unbolting the headunit. Watch the "Reverse" indication change from "On" to "Off"ħ) Turn the vehicle's ignition OFF Method 2: Check the back of the headunit to see if the wire is installed. exit all navigation screens and transition to the audio selection screen)Ĥ) Select "System Check". The process is the same, but menus and options will be different:ġ) Turn the vehicle's ignition ON(Start the engine. This will be different on other vehicles. Here's how we found the screen on our Subaru BRZ(The Subaru BRZ has the trigger wire installed from the factory). Most head units display the state of the reverse signal on one of the system information screens. This will save you the time required to install the reverse trigger and will also save you money.( The kit that does not include the reverse trigger wire is $2 cheaper) Method 1: Verify that the indication changes on the vehicle's touchscreen. Use one of these methods to determine if your vehicle already has the wire. Most vehicles are provided from the factory with the reverse trigger wire pre-installed. If the wire is not installed, the camera will not be provided power when the car is shifted into reverse and the backup camera will not work.ĭoes my vehicle have the reverse trigger wire installed from the factory? This will trigger the video screen to show the video from the backup camera on the screen and will energize the backup camera. The wire will provide a signal to the vehicle's head unit when the vehicle is in reverse. If a vehicle has a factory installed backup camera, it will have this wire installed as shown below. The wire provided with the kit sold here is approximatly 4 feet long. Why do I need the reverse trigger wire installed? How do I install the reverse trigger wire?
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |